Flashforge creator - will it work

What is the problem?

Will octoprint work with my creator. If not can I upgrade to creator pro or some other way to use octoprint

What did you already try to solve it?

Nothing yet

Have you tried running in safe mode and if so did it solve the issue?


Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)


Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible


Hello @chuckuntulis!

This site has a quite good search function. Searching for Flashforge will give you 37 results. One of these is this:

1 Like

I was wondering if anyone had checked into the anycubic kobra 2 pro. I would like to use octoprint, but I keep seeing that it will not connect. But I do not see it on your list. Can this be verified?

Hello @Radratonly !

This thread is about the Flashforge Creator.

There is another one for the Kobra 2

Please stick to the new thread, not the ancient ones.