I am using OctoPrint with Orange Pi Zero. It loses connection during printing and I can't resume it back. Here is the logs, I coudn't get anything. I am using ethernet cable for connection.
Upload the serial.log please
serial.log is currently not enabled, you can enable it via Settings > Serial Connection > Log communication to serial.log
I activated now.
I updated my logs properly.
unfortunately I see no reason for the disconnect.
- Is your power supply sufficient?
- try an other usb cable.
- Are there any electrical devices nearby that could cause emi?
- Did you turn anything on or off when it happened? (even a light)
I've got over 5 computers on work, over 5 pi, dremel and solder station, 4-5 switches and 2 access point, ups and lab type power supply They are all working, sleeping, rebooting consistently...
I've cut printer's USB's shield and power cables (for avoiding printer to power up orange pi) and on a USB dongle, there is USB Cam working with Octo. I am powering Orange Zero with 5V 2.4A USB power supply.
You should rather try this
If a better cable doesn't help the only thing I can advice you to is to switch to a stock Marlin with a matching example config.
My Ender 3 Pro disconnected everytime I turned off the fluorescent tube on the ceiling but as soon as I switched to a stock Marlin the problems were gone