Hello I own a Sovol SV03 and have been running an OctoPi server on a PI 4b since I got the printer. However lately I have to bendover backwards to get a part to start printing due to it giving the error during the initial bed heating. Initially it was happening after a par completed and I would start a new part. Now it's happening almost all the time.
There are no lose cables or worn wires either! The crazy part is that if I print off of sd card I dont seem to have any issues at all. I have even gone as far as installing a brand new OctoPi instance just to run into the same intermittent issue again.
The crazy thing is that once it gets past the initial heat up and starts printing it has no issues maintaining the temp and running the job no matter how long of a print the job is it finishes without errors.
Sorry if this is posted in the wrong location. This is my first time posting here.. Thanks for any assistance you can offer...
Yes the PI runs off it's own Raspberry official ac adapter and is the same setup I have been using for two years and only recently started having these intermittent to seemingly more often Bed heater warmup error events.