What is the problem?
After installing the emergency stop plugin I can no longer see the wrench icon. I am running octoprint 1.3.8 on octopi 0.15. I cannot run the latest on the pi connected to my Geeetech A20M because any later versions of octoprint strip out the Tn tool change commands
What did you already try to solve it?
Have you tried running in safe mode?
no, cannot find config.yaml and could not find an SSH command to start in safe mode.
Did running in safe mode solve the problem?
serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible